Mds-6a, 2 - w, Mcs c – Channel Plus MDS-6A User Manual
Page 10: Iring, Ontrollers, Cont
MDS-6A
INSTALLATION MANUAL
Page 10
© Channel Plus, Inc. 2004 • All rights reserved. 4/04
MCS Controller
DIP Switch Configuration
When connecting MCS Controllers to the MDS-6A, all dip switches on all MCS
Controllers should be configured to reflect their correct Zone ID.
NOTE: If more than one MCS Controller is to be installed in a single zone, all wiring
should be paralleled (as illustrated in Figure 6C on the previous page) and both MCS
Controllers should be assigned the same Zone ID.
2.2 - W
IRING
MCS C
ONTROLLERS
-
CONT
.
MDS-6A ZONE
1
2
DIP SWITCH #
1
2
3
4
5
6
X
X
X
X
X
X
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
ON
#1 ON=Back
Light OFF
#1 OFF=Back
Light ON
3
4
Figure 7