Panasonic NI-W950A - Manual (Page 10)

HOW TO USE THE “ SPRAY ” FEATURE
Note: Before using the spray feature, check the fabric label for ironing instructions. Some
fabrics may become spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening
is needed. >
The spray may be used with steam or dry ironing.
1. Simply pump the Spray Mist Button whenever spray is desired. If the spray doesn’t work
immediately, keep pumping until it does.
2. To get a finer spray, pump the Button repeatedly. To get a more powerful spray, pump the
Button more slowly. For best results, use a quick, full stroke.
® - v'.f ■ .;G. f . ‘.3 . r.o y
1. Set the Steam/Dry Selector to the Dry position.
2. Position the iron vertically, set the Temperature Selector to “ 0 ”.
3. Plug the mains lead into the household mains socket.
4. Set the Temperature Selector to the desired position. The Thermostat Operating Indicator
Light goes on. (Referto the FABRIC IRONING CHART on page 13)
» If the temperature of Soleplate is high, the light does not go on.
5. Preheat the iron until the Thermostat Operating Indicator Light goes out, usually it takes about
1 minute.
3-WAY CLEANBHG
WAY(1) Using the Self-Cleaning feature
1 . Fill the iron as described in “ HOW TO FILL WATER ”.
2. Set the Temperature Selector to the “ 0 ” position.
3. Plug the AC cord into the household mains socket.
4. Set the Temperature Selector to the “ MAX ” position.
5. Unplug the iron after the Thermostat Operating Indicator Light has gone out.
6. Hold the iron horizontally over the sink, press and hold the Self-Cleaning Button and gently
shake the iron to and fro. Impurities and scale (if any), together with steam and boiling water,
will be flushed out.
Then, turn to WAY (2).
WAY(2) Using the Jet of Steam feature
1. Repeat step 1 to 4 as described above.
2. Hold the iron horizontally over the sink after the Thermostat Operating Indicator Light has
gone out.
3. Pump the “ Jet of Steam Button ” quickly (at least 3 times per second) about 20-30 times.
While pumping, tilt the iron up and down slowly to help clean the entire inside and let the water
drip out of the soleplate vents.
4. Preheat the iron for about 5 minutes at “MAX” temperature when the iron has cooled without
button operation.
5. Unplug the iron.
6. Do not store the iron with water in it.
7. Iron on a used cloth to remove any impurities on the Soleplate.
■» Repeat WAY(1) and WAY(2) if the iron still contains a lot of impurities.
» Use both ways once every two weeks. If the water in your area is very hard (i.e. Steam holes
on the Soleplate are easily blocked by impurities), both ways should be used more frequently.
® Let the iron cool down on its Heel Rest and follow the instructions “ AFTER EACH USE ”.
10