Settings, Digiview data display brightness, Smartpower – Cobra Electronics XRS 9730 User Manual
Page 14: Bright, Dimmer, Dark, Pwr save, Power on, Power off

Nothing Comes Close to a Cobra
®
23
Settings
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
22 English
DigiView Data Display Brightness
Your detector has a Bright display mode (for daytime driving) and three levels
of Dim display modes (Dim for dusk driving, Dimmer for night driving and
Dark where no visual alerts will be displayed) to control the display’s
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Select/Dim Button
Press and release
Dark Indicator
.
To Change the Brightness to Dim
Press and release the
Select/Dim button once.
Tone
Visual Display
Voice
Two beeps
Dim, Dimmer
or Dark
Dim, Dimmer
or Dark
To Change the Brightness to Bright
Press and release the
Select/Dim button again.
Tone
Visual Display
Voice
One beep
Bright
Bright
NOTE
When you change to Dim mode, the unit will enter whichever
dim default mode is set at the time.
Intro
Operation
Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Dim Display
Dim
Bright Display
Bright
Dimmer Display
Dimmer
Dark Display
Dark
Settings
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
SmartPower
Your detector includes the SmartPower feature that, when activated, will put the
unit into Standby mode (low power) for about 30 minutes after the car’s engine
has been turned off. After 30 minutes in Standby mode, the unit will automatically
turn off.
Before SmartPower enters Standby mode, you will hear
one beep and Pwr Save will appear on the display. To
return the unit to normal Power mode or exit Standby
mode, start the car, press any button or turn the unit off
and then on again. The factory setting is SmartPower on.
SmartPower Entering
Standby Mode
Pwr Save
SmartPower On
...Power On
SmartPower Off
...Power Off
To Turn SmartPower Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to SmartPower.
Tone
Visual Display
Voice
Two beeps
SmartPower On
SmartPower On
One beep
SmartPower Off
SmartPower Off