Kofax Capture - Manual (Page 11)

Kofax Reporting Release Notes 11
Chapter 4
Additional Documentation
This section contains information missing in other official Kofax Reporting documentation.
Configuration of ETL Agent with WSA Receivers in an NLB Scenario
When configuring the ETL Agent via the Kofax Reporting Configuration tool, in the ETL
Settings > URL field, it is necessary to specify the URL of WSA Receiver or ESB in the central
site. This is correctly documented in the Kofax Reporting Administrator's Guide. However, when
you are using WSA Receivers in a network load balancing scenario, you need to enter the
individual URLs of all NLB nodes. Do not use the cluster IP address. (SPR00093400)
Reactivating Messages Manually with Message Queuing
When using either MSMQ or IBM MQ transport mechanism, messages that end up in the
storage of WSA Sender are not reactivated automatically. An administrator must reactivate
them manually. (SPR00101827)
Messages only end up in WSA Sender storage in error situations. For example, if you don't
select the WSA parameter RejectMsgOnMqError and the queue is not reachable, messages are
stored in the Inbound | Active folder.