Kistler-Morse KM ORB - Manual (Page 17)

TO SET UP THE VESSELS IN THE ORB
1. Log in to the ORB normally using a web browser.
User Login = Admin
Password = Admin
2. Scan for devices
a. Go to the NETWORKING tab
b. Click Set Up Serial Ports
c. Choose the Port that corresponds with the wiring of the ORB, click Configure
d. Choose the setting that matches the jumper setting (RS-485/MODBUS or KM/RS-422), click Update
e. Choose Manually Add Devices
f. Locate each serial address block (reference record table if required), click SCAN
g. Click continue, repeat until all devices have been successfully added. The ORB is now ready to
begin taking readings.
3. A company administrator should be set up, as well as, any additional user profiles. See Using the ORB,
Section VII for detailed instructions.
VII. USING THE ORB
TO SET COMPANY NAME AND LOGO
Choose ADMINISTRATION TAB/SET COMPANY NAME
1. Enter your company name and location
2. To add your company logo
a. Click Browse and find the file on your computer
b. Click the Use logo box
c. Click Update
3. Your name will now appear in the middle of the title bar, with the location underneath; the logo will be
updated on the left side of the screen. The ORB, iLevel logo will remain
TO UPDATE OR CHANGE THE TIME OF THE ORB
Choose ADMINISTRATION TAB/SET TIME AND DATE
1. User must have Write permission to make changes to this screen
2. Select the region of the units current location
3. Click Submit
TO ADD ADDITIONAL DEVICES
After the ORB has initially been set up, choose NETWORKING TAB/SET UP SERIAL PORTS
1. Choose the Port that corresponds with the wiring of the ORB, click Configure
13 13
97-1167-01 Rev. J
www.kistlermorse.com