Jaclo Deck Mount Diverter Rough - J-1209 - Manual (Page 2)

JACLO.COM
4 PORT DECK DIVERTER | PG 2
Installation Instructions
1 › Remove trim and smaller top valve nut (1) from valve.
2 › Provide 1-1/2" diameter hole in deck. Maximum deck
thickness is 2¼" for diverter only. Roman tub spouts
and valves may differ and must be checked.
3 › Thread bottom valve nut (2) all the way down on
valve (5).
4 › Slide valve (from underneath) through deck.
5 › Screw top valve nut (1) onto valve until top of stem
(3) is 2¼" above top of finished deck as shown. This
is important as it controls the space between handle
and escutcheon. Hand tighten bottom valve nut (2).
6 › Apply a small bead of silicone to the
bottom of the escutcheon and install onto valve.
7 › Install handle.
8 › Secure bottom valve nut (2).
9 › Install handshower (6) deck mount sleeve (7).
Connect handshower hose (9) to handshower base
(8) and to diverter valve.
10 › Connect hot and cold water supply to valve.
Note: Make sure any solder connections are at
least 1½" away from valve body.
2¼" to
Top of
Adapter
Deck
Cold Water
Inlet from ¾"
Deck Valve Hot Water
Inlet from ¾"
Deck Valve
¾" Outlet to Roman Tub
½" Outlet to
Handshower
Stem
Nipple
Valve Nut
Diverter Valve (5)
3
4
1
2
2¼" to
Top of
Adapter
Deck
Cold W
ater
Inlet fr
om ¾" Deck V
alve
Hot W
ater
Inlet fr
om ¾" Deck V
alve
¾" Outlet to Roman T
ub
½" Outlet to
Handshower
Stem
Nipple
Valve Nut
Diverter V
alve (5)
3
4
1
2
Hot Water
Inlet
Cold Water
Inlet
9
7
8
6
636 Lever
for illustration purposes only.
Parts
1
› Top Valve Nut
2 › Bottom Valve Nut
3 › Stem
4 › Nipple
5 › Diverter Valve
6 › Handshower
7 › Handshower Deck
Mount Sleeve
8 › Handshower Base
9 › Handshower Hose
½" IPS coupling