Jaclo Faucet, Lavatory Faucet - 6870-T684 - Manual (Page 4)

jaclo industries | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133
CREATED 8.6.2014
JACLO.COM | PG 4
Drain Assembly
1. Slip the top gasket (3) over the drain
tube (2).
2. Place drain tube through hole in
basin.
3. Install bottom gasket (4), mounting
washer (5) and mounting nut (6) onto
drain tube. Tighten using basin
wrench.
4. Place tube washer (13) into drain
body (14) and tighten into drain
tube, positioning side port toward
the back of basin.
5. Wrap the threads of the tail tube (7)
with two layers of teflon tape and
thread into drain body.
6. Insert drain plug (1) into drain tube.
Note: Drain plug style may vary
7. Insert ball rod seat (8) into side port
of drain body, carefully insert ball
rod (15) through the hole provided
in drain plug.
8. Thread ball rod nut (9) onto drain
body and tighten until snug.
DO NOT OVER TIGHTEN
9. With the lift rod in position on the
spout, insert the end into the lift rod
strap (10) as shown.
10. Slide the other end of the lift rod
strap onto ball rod, using the spring
clip (12) as shown.
11. Push the ball rod down to put drain
plug in full open position and adjust
the lift rod height so that the knob
rests on top of the spout.
12. Tighten lift rod strap screw (11) using
the adjustable wrench.
Handle Installation
1. Install handle onto stem in desired "off"
position.
2. Confirm handle is not binding with
escutcheon. Adjust valve nuts and
escutcheon if necessary.
3. Handles are fastened with a set screw or
top screw. Figure 6.
4. If set screw type, install washer and
screw, tighten then press in decorative
cap with o-ring.
5. If top screw type, install washer and
screw, tighten then press in decorative
cap with o-ring.
FIGURE 6