Jaclo Roaring 20's tub filler - 9930-T692- - Manual (Page 2)

JACLO.COM
roman tub | PG 2
ROUGH-IN INSTALLATION
1 › remove trim and top mounting nut from
valve. Check the mounting hole pattern and
hole size information as shown in FIGurE 1.
the 10" dimension may vary according to the
installation.
2 › Slide the deck housing fitting (7) through the
opening in deck. From the underside, slide
washer (8) over fitting (7), and tighten in place
using spout nut (9).
3 › Screw valve nut (15) all the way down on the
valve body. make sure that the fibre washer
(16) is on top of the nut.
4 › Install hot and cold valve bodies into the
holes in the deck.
5 › Install nut (15) on top of the valve body and
align the valve nut with the top of the valve
body to the dimension shown in FIGurE 2.
6 › rotate outlet of valve bodies to facilitate the
connection to the deck housing and secure
by tightening the bottom valve nut.
7 › repeat for the other valve.
8 › attach both valve outlets to the bottom
deck housing inlet. Follow the local code
requirements.
9 › attach supplies to the valve inlets (bottom
male thread of valve).
1