EKLIPES EKLIPE Black Classic Cobra Ultimate Motorcycle USB Charging System User Manual
Page 3
Once your battery harness is attached and you have to your battery correctly then Plug in your unit with
the SAE Plug to the Matching SAE Plug Connector and test your Cobra unit you are ready to install the
mount.
Determine which size of handle bar you have on your motorcycle, 7/8 inch, 1 inch, or 1 ¼ inch
handle bar.
The most common handle bar on most bikes is a 1 inch handle bar. If this is the case with regards
to your handle bars then the mount already has the 1 inch insert ring in the mount for your
handle bar.
1 inch insert ring on handlebar >>>>>>>>>>>>>>>>>>>>
Take the mount apart by un-screwing the Phillips screw and
the mount will come apart. Then you will see the 2 half’s of
the chrome insert ring >>>>>>>>>>>>>>>>>>>>>>>>>>>
To prevent any possible scratching of your bars take Black
Electrical tape and do 1 small wrap around the Bar exactly
where you want the mount to go. Then Place the two
halves of the insert ring around the handle bars exactly
where the tape is >>>>>>>>>>>>>>>>>>>>>>>>>>>>>