CuiZen 10-speed Blender CBL-1048 - Manual (Page 5)

5
OPERATING INSTRUCTIONS
1. Wash ingredients to be blended and cut them into pieces small enough to fit into
Removable Filler Cap Feeding Hole.
2. Once cleaned and cut, add ingredients into Blender through Feeding Hole. NOTE: Pitcher
has a six cup (48 oz. / 1.5 liter) capacity. Do not overload Pitcher. Do not fill more than 2/3
full with food or liquid.
3. After filling the Pitcher with ingredients, secure Lid into position. Plug Blender into a
standard 120-volt AC electrical outlet.
4. Push desired blender speed button “LOW” or “HIGH”, then select function button:
PULSE, BLEND, GRIND, LIQUEFY, ICE CRUSH. Note: Both Blender Speed & Function
buttons must be pushed in or Blender will not operate.
10-SPEED OPTIONS
LOW-SPEED PULSE (Low + Pulse)
STIR (Low + Blend)
PURÉE (Low + Grind)
CHOP (Low + Liquefy)
GRATE (Low + Ice Crush)
HIGH-SPEED PULSE (High + Pulse)
BLEND ( High + Blend)
GRIND ( High + Grind)
LIQUEFY (High + Liquefy)
ICE CRUSH (High + Ice Crush)
CAUTION: Never operate motor for more than a few minutes at a time. Select and depress
Blender speed & function buttons, run for a minute or two, then turn unit “OFF” and allow motor
to cool for a few seconds. Press Blender speed & function buttons again until desired results are
achieved. DO NOT use Blender for blending heavy foods or thick mixtures.
NOTE: PULSE Button can be used for more control during short processing jobs to run Blender
motor at”LOW” or “HIGH” speed. When finished processing ingredients with “PULSE” Button
feature, release “PULSE” Button, then push “OFF” button to turn off Blender.
5. To turn off Blender, press “OFF” Button on the 10-Speed Control Panel.
6. Unplug Blender from electrical outlet when finished blending ingredients, when the
product is not in use, or if leaving unattended. CAUTION: Always unplug Blender from
electrical outlet before assembling, disassembling, or cleaning it.
If Blender motor does not run freely while blending ingredients, perform one or more of the
following steps, as necessary:
1. Press “OFF” Button and add water/liquid to ingredients blending.
2. Press “HIGH” Speed Button then “PULSE” Button for a few minutes until motor blends freely.
3. Press “OFF” Button, unplug Blender from electrical outlet and use a rubber spatula/scraper
to clear the sides of the Pitcher and push the ingredients toward Blades.
4. Reduce the amount of ingredients inside Pitcher.