Cub Cadet GT-2550 - Manual (Page 42)

42
LUBRICATION
After every 10 hours of operation and/or before putting
the deck into winter storage, lubricate the spindle as-
semblies and the spindle belt idler arm with 251H EP
grease or an equivalent No. 2 multipurpose lithium
grease. Excess grease will be expelled from the invert-
ed upper seals of the spindle assemblies. Listen for
the muffled crackling noise of grease being expelled
through the seal to indicate the spindle assembly is ful-
ly greased. Refer to Figure 54.
Every 50 hours, or twice yearly, lubricate the double
pulley with 251H EP grease or an equivalent No. 2
multipurpose lithium grease. Do not over lubricate.
Refer to Figure 54.
Figure 54
SPINDLE DRIVE BELT REPLACEMENT
In order to replace the spindle drive belt, refer to Figure
54 and Figure 55 and proceed as follows:
1. Disengage the idler arm lever from its stop bracket
and rotate the lever to the outside of the deck to
release the spring tension.
2. Remove the hardware that secures the spindle
belt covers to the deck.
3. Remove the spindle belt covers to expose the belt.
4. Pull the movable flat idler pulley away from the
backside of the belt and remove the old drive belt.
5. Install a new belt on the spindle pulleys and
position the flat idler pulley against the backside of
the belt so that the belt is tensioned. Refer to
Figure 55 for the proper routing of the belt.
6. Reinstall the spindle belt covers.
7. Engage the idler arm lever into its stop bracket.
Figure 55
1
2
4
3
5
6
5
5
2
1
1. Spindle Belt Cover
2. Hex Tapp Screws
3. Idler Arm Lever
4. Stop Bracket 5. Spindle Assembly
Grease Fittings
6. Idler Arm
Grease Fitting
7
7. Double Pulley
6
1
2
3
4
1. Movable Idler Pulley
2. Spindle Drive Belt 3. Idler Arm Lever
4. Fixed Idler Pulley