beautypg.com

36 en, Emc table – Compex SP8.0 User Manual

Page 38

background image

36

EN

8. EMC TABLE

The Compex Stimulator requires special precautions regarding EMC and needs to be installed and put into
service according to the information provided on the EMC in this manual.

All RF wireless transmission devices can affect the Compex Stimulator. The use of accessories, sensors,
and cables other than those specified by the manufacturer, may result in greater emissions or reduce the
immunity of the Compex Stimulator.

The Compex Stimulator should not be used beside or stacked on other equipment, if adjacent or stacked
use is necessary, one must check the correct functioning of the Compex Stimulator within the context of the
configuration used.

RECOMMENDATIONS AND DECLARATION BY THE

MANUFACTURER CONCERNING ELECTROMAGNETIC EMISSIONS

The Compex Stimulator is intended for use in the electromagnetic environment specified below.

The customer or user of the Compex Stimulator should ensure that it is used in this environment

EMISSIONS TEST

COMPLIANCE

ELECTROMAGNETIC ENVIRONMENT

- GUIDE

RF emissions

CISPR 11

Group 1

The Compex Stimulator uses RF
energy only for its internal operation.
Consequently, its RF emissions are
unlikely to interfere with any adjacent
electrical device (radios, computers,
telephones etc.).

RF emissions

CISPR 11

Class B

Compex Stimulator is suitable for use in
any establishment, other than a private
dwelling or a place connected directly
to the low voltage mains supply which
powers residential buildings.

Harmonic emissions

IEC 61000-3-2

Class A

Voltage fluctuations/ emission

oscillations IEC 61000-3-3

Not applicable

This manual is related to the following products: