Checkline LS-5-12000 - Manual (Page 3)

- 3 -
3.0 O VERVIEW
Metal Enclosure
Flash Tube
Reflector
Screw-Off Plastic Lens
On Back: Sockets for trigger input
and supply voltage, ON/OFF Switch,
LED Power Indicator
Plug for trigger input and
power supply
On Bottom: 3 threaded holes for
equipment mounting, tripod connection
Optional Accessories
• Spare flash tube
• Tripod / wall mounting bracket
• Power supply unit
• Additional plug for trigger
input / power supply
• Connecting cable with plug
connector to the LS-5-12000
and open cable connection
for external equipment
• LS-5-RCU Control Unit
(not shown)
- 6 -
5.0 O PERATION
1. Position the stationary
stroboscope and connect the
trigger input signal and supply
voltage to the sockets as outlined
in Section 4.0
2. Switch the stroboscope on. The
red LED will light, indicating that
the unit is ready for use.
2 . As soon as the trigger signal is
applied, the strobe will start to
flash with the trigger frequency.
3. If the flashing frequency coincides with the movement frequency,
a stationary image will appear.
NOTE: A stationary image will not only appear with an identical
flashing frequency, but also with multiples and fractions of
the flashing frequency.