Ashdown ABM NEO C210 - Manual (Page 9)

www.ashdownmusic.com www.ashdownmusic.com 9
USER MANUAL
EB LITE 220
dIRECT INJECT ( d.I. )
A balanced d.I. Is provided on the front panel XLR socket. This provides a post E.Q. Post effects signal.
The output signal from this XLR socket is set to a level and impedance suitable for connecting directly into a balanced microphone input of a mixing
desk for either direct injection into the pa system or for recording.
EFFECTs sENd/RETURN
A serial effects loop is provided at a level of 0db. The effects send and return sockets for this are on the front panel below the d.I. socket.
The effects send socket can also be used as a line out socket if required. The signal path through the preamp is only broken when a jack plug is
inserted into the effects return socket. The effects send is situated after the E.Q.
TUNER/LINE OUT
This output socket provides a line level signal that can be used either for a permanent connection to a tuner or a line output for connection to other
power amplifiers and speakers.
OUTPUT LEvEL
The output control adjusts the overall level of the amplifier. Adjust this for your preferred overall stage playing volume.
Everything possible has been done to make these reliable, minimum service, high quality, long lasting powerful bass amplifiers.
We know you will appreciate the effort that has been put into the design and manufacture of this unit and you will be rewarded in your choice of
bass amplifier by long life and reliability.
INPUTs
High Input Impedance - 3.9M ohms Input range 150mv to 20v p - p
Low Input Impedance - 10k ohms Input range 300mv to 40v p - p
Effects Return Impedance - 22k ohms Input level 0dbu nominal
OUTPUTs
Tuner Output Impedance - 10k ohms Level 0dbu nominal
Effects send Impedance - 22k ohms Level 0dbu nominal
d.I.Output 600 ohms balanced Level -20dbu nominal
speaker Outputs Minimum Impedance - 4 ohms
Frequency Response -3db at 22hz and 25khz
EQUALIsATION
Bass +/- 15db @ 100hz
Lo Mid +/- 15db @ 340hz
Middle +/- 15db @ 660hz
Hi Mid +/- 15db @ 1.6khz
Treble +/- 15db @ 7khz shelving
deep + 8db @ 50hz
Bright + 10db @ 10khz
signal to Noise Better than 80db (E.Q. Flat)
distortion Less than 0.5% THd
Output Power 220watts RMs into 4 ohms.
Ashdown Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Ashdown 2011. Ashdown Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Ashdown 2011.
Sp
E
c
If
Ic
A
TI
o
NS