Pet ether v exit Page 26: Ets relay - on, Analog exit ^ v, Outputs exit v
Page 26: Ets relay - on, Analog exit ^ v, Outputs exit v
Operator’s Manual
pg. 26
Rev F 12/08/14
7.
Press the Up Arrow button (^) on the Keypad to exit Diagnostics.
Press the Up Arrow button (^) on the Keypad up to three more
times to return to your solvent screen (example shown to the
right).
Check the state of the ETS (Emergency Temperature Shut-off switch) relay
To check the state of the ETS relay, follow the procedure below.
1.
Access the Diagnostics screen (see the "Access Diagnostics
Screen" section for details).
2.
With the Diagnostics screen displayed, press the
ENTER button on
the Keypad. The screen to the right will be displayed.
3.
Press the Down Arrow button (
v) on the Keypad. The screen to the
right will be displayed.
4.
Press the Down Arrow button (
v) on the Keypad. The screen to
the right will be displayed.
5.
Press the
ENTER button on the Keypad. The screen to the right
will be displayed showing the state of the ETS relay. If the ETS
relay is "OFF", contact ANKOM Technology.
6.
Press the
STOP button on the Keypad to go back to the Inputs
screen (shown to the right).
7.
Press the
STOP button on the Keypad to go back to the main
Diagnostics screen (shown to the right).
8.
Press the Up Arrow button (^) on the Keypad to exit Diagnostics.
Press the Up Arrow button (^) on the Keypad up to three more
times to return to your solvent screen (example shown to the
right).
PET Ether
v
Diagnostics
^
Inputs
Exit
ETS relay - ON
Inputs
Exit
Analog
Exit
Outputs
Exit
Diagnostics
^
PET Ether
v