360 Systems Short/Cut Editor User Manual
Page 42
Page 34
Editing
360 Systems
Note that increasing gain can cause distortion in audio that is already recorded near full
scale; in this event simply U
NDO
the operation or reduce the gain of only the affected audio.
0 db (default)
+6 db maximum
-
90 db minimum
EDIT OUT MARK
EDIT IN MARK
Adjust Level
Adjust Level allows the gain of a selected range of audio to be increased or decreased
relative to its current Gain Value. This allows the relative levels of gain edits and fades
performed on small regions to be maintained when they are subsequently adjusted as part of a
larger region.
Adjust Level also has the ability to set an in and out fade time. These times occur within
the time defined by the Edit In and Edit Out marks, so their total cannot exceed the length of
the selected range. The graph below shows an Adjust Level operation that adds 4 db, with the
Fade In time set about half the length of the Fade Out time.
Fade Out Time
Fade In Time
0db
+4db
Gain Adjust = +4db
The Adjust Level display has four lines:
ADJUST LEVEL
1. 4
4
4
4ADJUST NOW
2.
ADJUST BY:
+00.0
DB
3.
FADE IN TIME:
00.00 SEC
4.
FADE OUT TIME:
00.00 SEC
The first item is A
DJUST
N
OW
. This executes the operation using the information entered
on lines 2, 3 and 4. This information is remembered from the last operation, so if you are using
the same values you can simply press E
NTER
. To change the values, press the number
corresponding to the line number. For instance, pressing 2 selects the A
DJUST
B
Y
value.