Cub Cadet SWE 528 - Manual (Page 14)

14
6
Maintaining
Your Snow
Thrower
WARNING
Always stop engine,
disconnect spark plug,
and ground against
engine before performing
any type of maintenance
on your machine.
IMPORTANT: Avoid oil
spillage on rubber friction
wheel and aluminum
drive plate. Do not overfill
the gear case. Damage to
the seals could result.
Figure 18
Figure 19
WARNING: Always stop engine and
disconnect spark plug wire before
performing any type of maintenance
or adjustment. Always wear safety
glasses during operation or while performing any
adjustments or repairs.
General
Recommendations
• Always observe safety rules when performing any
type of maintenance.
• The warranty on this snow thrower does not cover
items that have been subjected to operator abuse
or negligence. To receive full value from warranty,
operator must maintain the snow thrower as
instructed here.
• Some adjustments will have to be made periodically to
maintain your unit properly.
• Periodically check all fasteners and make sure these
are tight.
Engine
Refer to the separate Tecumseh Engine manual packed
with your unit for all engine maintenance.
Lubrication
1. Drive Mechanism: Once a season or after every
25 hours of operation, remove rear frame cover and
lubricate any chains, sprockets, gears, bearings, and
shafts with engine oil or lubricant spray.
2. Hex Gear Shaft: Once a season, lubricate the hex
shaft with a penetrating oil, but not grease.
3. Gear Case: The gear case is lubricated with grease
at the factory and does not require regular lubrication.
However, if disassembled for any reason, lubricate
with 2 ounces of Shell Alvania™ grease (part #
737-0168). Before reassembling, remove old sealant
and apply new sealant.
4. Wheels: Once a season, remove the bolt from
each wheel and take the wheel off the axle. Apply a
multipurpose automotive grease on the shaft before
putting back the wheels.
5. Auger Shaft: At least once a season, remove the
shear pins on auger shaft. Spray lubricant inside shaft,
around the spacers. Also lubricate the flange bearings
found at either end of the shaft. See Figure 18.
6. Drive/Auger Control Lock: The cam on the ends of
the control rods which interlock the drive and auger
controls must be lubricated at least once a season
or every 25 hours of operation using a multi-purpose
automotive grease. The cam can be accessed
beneath handle panel.
7. Engine: Refer to the separate Tecumseh Engine
manual packed with your unit for all engine lubrication
instructions.
Augers
The augers are secured to the spiral shaft with two shear
pins and cotter pins. See Figure 19. If you hit a foreign
object or ice jam, the snow thrower is designed so that
the pins will shear.
1. If augers do not turn, check to see if pins have
sheared.
2. Replace the pins if needed. Two replacement shear
pins and cotter pins have been provided with the
snow thrower. Spray an oil lubricant into shaft before
inserting new pins and securing with new cotter pins.
See Figure 19.
IMPORTANT: NEVER
replace the auger shear
pins with standard pins.
Any damage to the auger
gearbox or other compo-
nents, as a result of doing
so, will NOT be covered
by your snow thrower’s
warranty.
3HEAR
"EARING
3PACERS