Tire-SafeGuard External TPMS - Manual

HCI Corporation External TMPS Install 1
External TPMS Installation
Note: Install antenna and turn on monitor before installing sensors, for capturing
and displaying the newly pressurized sensor readings during installation
1. Monitor
• Driver side on dash is a better signal monitoring location than the center of the dashboard
• Turn on/off monitor with the battery switch in the back side
• After switched on, the monitor will clear all prior readings and show “- -“ for each tire
• Turning on monitor after sensor installation may need up to two hours for sensor readings to
appear; the sensors send few signals when vehicle is not moving for saving battery power.
2. Sensor vs. Tire Location Mapping
4 / 6 / 8-tire Truck / Motorhome Sensor Mappings
2 / 4 / 6-Tire Car / Trailer Sensor Mapping