STIEBEL ELTRON GALAXYTM Series Automatic Hand Dryer - Manual (Page 2)

LIMITED WARRANTY
STIEBEL ELTRON, Inc. warrants to the original owner that the GALAXY TM hand dryer will be free from
defects in workmanship and materials for a period of FIVE YEARS from the date of purchase. Should
any part(s) prove to be defective under normal use during this period, STIEBEL ELTRON, Inc. will be
responsible for replacement of the defective part(s) only. Damage to the housing due to abuse is not
covered by this warranty. STIEBEL ELTRON, Inc. is not responsible for labor charges to remove and/or
replace the defective part(s), or any incidental or consequential expenses. Should the owner wish to
return the entire unit for repair, the owner must first secure written authorization from STIEBEL ELTRON, Inc.
The owner shall be required to show proof of purchase date by including a copy of the original
invoice, and to pay all transportation costs to return defective part(s) or hand dryer for repair or
replacement.
IF YOU NEED TO RETURN A PART OR A HAND DRYER UNDER WARRANTY, PLEASE CALL US FIRST TO
OBTAIN SHIPPING INSTRUCTIONS. REMEMBER TO SEND A COPY OF THE INVOICE WITH YOUR RETURNED
PART.
STIEBEL ELTRON, Inc.
17 West Street
West Hatfield, MA 01088
Phone: 800-582-8423
Operating Instructions
for the user
In order to dry your hands most efficiently, please use the
following procedure:
• shake off excess water over the wash basin
• place hands underneath the unit at a distance of 4" - 7"
• rub your hands together as if you were washing them
Your hands will be dry within 25 - 35 seconds.
The STIEBEL ELTRON GALAXY TM series hand dryers are equipped
with an infrared sensor switch. This sensor will activate the unit
when hands are placed underneath it. Approximately 7
seconds after the hands have been removed, the unit will
automatically shut off.
The sensor is the black rectangle located underneath the unit
between the air exit and air inlet grills. The sensor switch will not
work properly if it has been covered by gum or dirt. If the sensor
is obstructed, the hand dryer will switch off automatically to
prevent it from running continuously. Should the unit overheat,
a safety high-limit switch will turn off the heating element. The
safety high-limit switch resets automatically once the heating
element has had a chance to cool down.
Normal Care
To clean the case use a soft cloth with a mild detergent if
necessary. Never use any abrasive cleaners since they will
scratch the finish of the unit. Never spray water or cleaning
fluids directly on hand dryer. While cleaning the unit, make sure
the electric eye switch is not covered. THE GALAXY TM HAND
DRYER DOES NOT CONTAIN ANY PARTS SERVICEABLE BY THE LAY
PERSON. IN CASE OF MALFUNTION PLEASE CONTACT A LICENSED
ELECTRICIAN.
48
"120
cm
min. 4" 10 cm
FIG. 1