Panasonic ES726 - Manual (Page 7)

power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for 8
hour if you will not be taking the
charging adaptor with you.
For a better shave
Put a thin tayer of shaving foam on
your face which works as lubricator.
Shaving foam is the most suitable
among many other shaving aids(gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it becomes
messy. If the shaving head is clogged
with foam, simply rinse it under run­
ning water.
Hold the shaver at a right angle (90°)
to your skin (see fig. 3). Depress the
switch lock button and slide the On/
Off switch upward to turn the shaver
on. Start out shaving by applying
gentle pressure to your face. Stretch
your skin with your free hand and
move the shaver back and forth in
the direction of your beard. You may
gently increase the amount of pres­
sure as your skin becomes accus­
tomed to this shaver. Applying exces­
sive pressure does not provide a
closer shave.
Using the trimmer
(see fig. 4)
Shavirig longer, curly hairs under
the chin
Slide the trimmer switch up to the 1st
position. This position makes the
trimmer an intercept cutter, cutting
long hairs while the outer foil shaves
shorter hairs. Make sure that the trim­
mer is facing outward away from the
neck.
Trimming sideburns (see fig. 5)
Slide the trimmer switch up to the 2nd
position.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
After every shave, press the foil frame
release button to pop open the foil
frame. Turn the shaver on and rinse
the inner blade(s) under running
water or in a basin (see fig. 6). After
rinsing, switch the shaver off and
leave it to dry without closing the foil
frame and the protective cap. After
the shaving head dries, close the foil
frame and replace the protective cap
on the shaver.
Replacing shaving head
components
With daily use, and depending on
thickness of beard, the outer foil may
need to be replaced every year and
the inner blade(s) every 2 years.
Replacing the outer foil
(see fig. 7)
Squeeze the outer foil release but­
tons and lift the outer foil upward to
remove it. To insert the new outer foil,
press down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Press the foil frame release button
to pop open the foil frame. Pull the
foil frame vertically out of the upright
shaver. Remove the inner blade one
at a time by grasping it firmly at both
ends and pulling straight away from
the shaver. To insert the new inner