Caution – Panasonic ES8023 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Replacing the inner blades
{see fig. 8)
Squeeze the foil frame release but
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
ATTENTION:
A nickel cadmium battery (s) that
is recyclable powers the product
you have purchased. At the end
of it’s useful life, under various
state and local laws, it is illegal
to dispose of this battery (s) into
your municipal waste stream.
Please call 1-800-8-BATTERY for
information on how to recycle this
battery (s).
purpose of proper disposal.
1. Remove the two screws (a).
2. Pull the chassis {b) out of the
housing.
3. Turn the chassis over and remove
the battery (s) (c).
WARNING:
Do not attempt to replace the bat
tery (s) (or the purpose of reusing
the shaver. This could result in the
risk of fire or electric shock.
How
to
remove
the
built-in
rechargeable battery (s) before
disposal of the shaver
(see fig. 9)
The battery (s) in this shaver is not
intended to be replaced by consum
ers. However, the battery (s) may be
replaced at an authorized service
center.The procedure described be
low is intended only for removal of
the rechargeable battery (s) for the
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40“C (104“F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE3-89 to charge
the ES8023/ES8024 shaver.
• The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
• Dry the shaver completely before
setting it in the charging adaptor.
• Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap
tor to an outlet.
• The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg
ing adaptor for a few minutes and
check again to make sure that it is
being charged.