Panasonic EW3122 - Manual (Page 10)

STORING MEASUREMENT VALUES
Alarm function signals high blood pressure
Blood pressure values for both systolic and diastolic readings are
determined and Indicated via a three-color LED system as being within
normal or hypertensive ranges based on definitions and classification of
blood pressure levels by the JNC 7. Moreover, when blood pressure Is In
the high range, the reading displayed on screen flashes on and off to alert
user.
According to JNC 7 Classification, values consistently In excess of 140
mmHg (Sys.) and/or 90 mmHg (DIa.) are considered to constitute high blood
pressure.
This product can separately store 42 measurements
3 color light system
BHypertension
■ Prehypertension
■ Nornial
I Blood
I Pressure
hSip
■Prehypertension
i Normal
LED Color
Diastolic
(mmHg)
^ Orange
> Yeilow
90
80
Green
Hypertension
(Stage 1, Stage 2)
Prehypertension
Normal
120 140 (mmHg)
Systolic
Blood pressure readings will flash for approx. 6 seconds
when In the high blood pressure range.
Systolic blood pressure: 140 mmHg and over
Diastolic blood pressure: 90 mmHg and over
(Only when measurement Is complete)
If measurements could not be taken properly
The remeasure mark E will be displayed.
When taking successive measurements, press the
Start/Stop button to switch off the blood pressure
monitor once and stay quiet for 4 to 5 minutes, and then
take the next measurement.
Advice:
In general, blood pressure measurements are lower for the second measurement because you
are less nervous and are more tranquil.
For people who easily get tense, measuring twice each time is very effective.
When two measurements are taken, normally the smaller measurement Is stored.
When taking two measurements, always stay quiet for 4 to 5 minutes after the first measurement
before taking the second measurement.
each for two persons.
On/Off
Start
Panasonie
SYS.
nnrHg
DiA.
mnt^
PuMnta
B/ 3 Ì5-30
(38
88
EP
i9i “q?
1
On/Off
Start
After measurement, the f?l will light.
Press the Memory/Recall
button with the number
corresponding to the person for which
measurements should be stored.
Example: Person A: Press
Person B: Press (2I
M/R
Storing is compieteci.
• Up to 42 measurement values can be stored.
When the memory is full and additional values
are stored, the oldest value in memory will be
deleted and the new value will be stored.
• If measurements could not be taken properly
(the E mark is shown instead of the blood
pressure value), measurement values cannot
be stored.
• However, even if the £ mark Is shown for the
blood pressure value, the pulse value will still
be stored.
Number of stored data
To erase all measured values stored in memory:
1. Press the Memory/Recall button for the person whose data you want to delete.
The stored measurement values will be displayed.
2. Press the same Memory/Recall button again, and hold It pressed until the
measurement values disappear (approximately 3 seconds or more).
* It is not possible to erase single measurement values.
To switch off the blood pressure monitor,
press the On/Off Start button.
• If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 5 minutes.
17 18