Remote control, Remote controlling two palmcorders, Ir remote control – Panasonic PALMCODER PV-DRC9 User Manual
Page 3: Controlled functions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IR Remote Control
Remote Control
You can operate the major functions of your Palmcorder from up to approximately 16 feet
(5 m) away (indoors). Aim the IR Remote Control toward the front of the Palmcorder and
press the desired buttons (sensor is located under the lens).
To operate Camera functions:
Set the POWER Switch to CAMERA.
To operate VCR functions:
Set the POWER Switch to VCR.
Controlled Functions
Rec/Pause
»Tele (Zoom)
Wide (Zoom)
Reset
Display On TV
Audio Dubbing
Menu
FF/Search
Pause/Select
Date/Time
Photo Shot
CounteryTime Code
Record
Play
REW/Search
Stop/Set
Slow/Frame Advance (Fonward)
Slow/Frame Advance (Backward)
Index Search (Forward)
Index Search (Backward)
Speaker Volume
Remote Controlling Two Palmcorders
You can control any two PV-DV900’s with
one IR Remote control. In order for the
remote to distinguish between the two
units, it is necessary to set one of the
Palmcorders to VCR 2. On the remote,
press VCR 1 or VCR 2 to control the
desired Palmcorder.
1
Display the menu and select REMOTE
VCR 2 on one Palmcorder. Leave the
other Palmcorder set to VCR1.
(3 REC MODE
«1 t)
R€C«PE£I>
«SP
U»
AUC9lO-ftEC
•12bK
16bH
SHtfTTEA «OFF
ON
•OFF
ON
OFF VCRI 9VCK2
•OAY
3«3UR
OFT
moH
BEEP
OFF
»ON
{4 OtSPLAY SETTWQ
TALLY-LED
For VCR 1 :
Press these
buttons at the
same time.
Set the Remote Control to VCR 1 or
VCR 2 to correspond with the
Palmcorder you wish to control.
(See illustration at left.)
Note:
----------------------
• When the Palmcorder
and remote are not set
to the same mode
(VCR1 or VCR2),
“CHECK REMOTE ^-------------------------------
MODE" will appear.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.