Chamberlain NLS1C - Manual (Page 2)

2
Assemble Intercom
Step 1
Install 4 AA Alkaline batteries (not provided).
Step 2
Adhere rubber pads to bottom. Repeat Steps 1 and 2
for any additional intercoms.
Programming Intercom
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Before programming, clear memory on all intercoms.
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put the second
intercom into Learn Mode (refer to the following table).
Each intercom will emit a tone when entering
programming mode. It may take up to 3-1/2 minutes
for a secure network to be established. Repeat for any
additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put any networked
intercom into Learn Mode (refer to table below).
Each intercom will emit a tone when entering
Programming Mode. It may take up to 3-1/2 minutes
for a secure network to be established. Repeat for any
additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form
a separate network and the memory will need to be
cleared.
Press and release the Talk button to verify network is
complete.
MONITO
R
HOL D
OFF
1 3
2 4
VOLUME
T A LK ACTIVE
MONITO
R
HOLD OFF
1 3
2
4
VOLUME
T A LK ACTIVE
VOLUM
E
MONIT OR
CHANNE
L
HOLD
OFF
ACTIVE
TALK
1 3
2
4
INTERCOM LEARN MODE
Press the Learn button
until a beep is heard.
OR HOLD
ACTIVE
TALK 1 3 2 4
VOLUME
MONITOR
CHANNEL
OFF
INTERCOM LEARN MODE
Press the Learn button
until a beep is heard.
OR HOLD
ACTIVE
TALK 1 3 2 4
VOLUME
MONITOR
CHANNEL
OFF