Save these in structions, For battery charg er & bahery pack, Caution – Panasonic EY6406 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/653946/4/background.png)
FOR BATTERY CHARG
ER & BAHERY PACK
> SAVE THESE IN
STRUCTIONS ™.
manual contains important safety and
operating
instructions for battery
charger EY0230.
2) Before using battery charger, read all
instmctions and cautionary markings
on (1) battery charger. (2) battery
pack.
3)
CAUTION
-To reduce the risk
of injury, charge only Battery Pack
shown below.
EY9001, EY9080, EY9065. EY9006,
EY9086, EY9101, EY9180, EY9182,
EY9106, EY9107, EY9136, EY9230,
EY9200, EY9108
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or
snow.
5) To reduce risk of damaging the elec
tric plug and cord, pull by ^ug rather
than cord when disconnecting charg
er.
6) Make sure cord is located so that it
will not be stepped on, tripped over,
or otherwise subjected to damage or
stress.
7) An extension cord should not be
used unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be
used, make sure:
a. that pins on plug of extension cord
are the same number, size and
shape as those of plug on charger.
b. that extension cord is properly
wired and in good electrical condi
tion.
c. that wire size is large enough for
ampere rating of charger as speci
fied below.
- 4
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Amperes
AWG Size of Cord
Equal to or But less
greater than than
Length of Cord, Feet
25 50 too 150
0 2
18 18 18 16
8) Do not operate charger with dam
aged cord or plug—replace them
immediately.
9) Do not operate charger if it has
received
a
sharp
blow,
been
dropped, or otherwise damaged in
any way; take it to a qualified service
man.
10) Do not disassemble charger; take it
to a qualified serviceman when ser
vice or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting
any
maintenance
or
cleaning.
12) The charger and battery pack are
specifically designed to work togeth
er. Do not attempt to charge any
other cordless tool or battery pack
with this charger.
13) Do not attempt to charge №e battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery
pack in locations where the tempera
ture may reach or exceed 122°F
(SOX) (such a metal tool shed, or a
car in the summer), which can lead to
deterioration of the storage battery.
16) Do not charge battery pack when the
temperature is BELOW 32°F (0“C) or
ABOVE 104°F (40°C). This is very
important.
17) Do not incinerate the battery pack. It
can explode in a fire.