Panasonic EY6930 - Manual (Page 8)

0
Battery charger (EY0212/EY0213)
Note: When you charge the battery
pack for the first time, or after
prolonged
storage, charge it
for about 24 hours to bring the
batteries up to full capacity.
1. Plug the charger into an AC outlet.
2. Open the cap and Insert the bat­
tery pack firmly .ip|oth^p^ai^r.
To AC
outlet
Battery
pack
Battery
charger
• When charging, cooling fan In the
charger functions to cool down the
battery pack, and the sound of fan
can be heard. This is normal. If this
sound cannot be heard, it Is a
malfunction. Stop charging
immediately and consult an
authorized dealer.
3. During charging, the charging
lamp wilt be lit.
When charging is completed, an
internal electronic switch will auto­
matically be triggered to prevent
overchcuging.
• Charging will not start if the bat­
tery расж is warm
immediately after heavy-auty
operation), the orange standby
lamp will be lit until the battery
cools down. Charging wilt then
begin automatically.
4. When charging is completed, the
charging lamp will start flashing
rapidly.
5. When in any of the conditions that
the charger is too warm, battery
pack is too cool, or the battery
pack has not been used for a long
time, the charging lamp starts
flashing slowly to indicate protec­
tive charging. Protective charging
takes longer to fully charge the
battery pack, than the standard
charging time.
(Max. charging time is approx. 90
minutes.)
• If a fully charged battery pack is
inserted into the charger again,
the charging tamp may light up
and then flash slowly. After sever­
al minutes, the charging lamp
may flash quickly to indicate the
charging is completed.
6. If tfie charging tamp does not light
immediately after the charger is
plugged in, or if after the standard
charging time the lamp does not go
off, conduit an authorized dealer.
Note: • When charging a cool battery
pad( (below 5**C) in a warm place,
leave the battery pack at the place
and wait for more than orre hour to
warm up the battery to the level of
the ambient temperatore. (Battery
pack may not be fully charged.)
• Cool down the charger when
charging more than two battery
packs consecutively.
CAUTION: «Do not use power source
from an engine generator.
• Do not cover vent holes on
the charger and the battery
pack.
LAMP INDICATION
Charger is plugged into a wall outlet.
Ready to charge.
] Now charging
Charging Is completed
— CZ3 Protective charging
Battery pack is warm. Charging will begin
when temperature ol battery (wck drope.
Charging is not possible. Clogged with
duet or malfunction o( the battery peck.
-
8
-