Cleaning secondary foam filter, Replacing hepa exhaust riter, Юшыёш|шшшмё1 – Panasonic MC-V7380 User Manual
Page 15: Limpieza del segundo filtro de goma espuma, Cambiar del filtro de escape hepa, Segundo fìltm de goma espuma, Cubierta, Filtro de, Hepa y el marco
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ЮШЫЁШ|ШШШМЁ1
Performing the following tasks will keep your new Panasonic vacuum cleaner operating at
peak performance levels and will ensure these high levels for years to come. Check the
BEFORE REQUESTING SERVICE section In this manual for recommendations on performing
some of these tasks to help solve various problems that may occur.
Siguiendo
/as /nsfrucc/ones dadas, se nueva
aspiradora Panasonic funcionará al nivel máximo y
continuará funcionando por mucho años en el ^turo. Lea la sección “Antes de pedir servido“ en este
manual para las recomendaciones para arreglar unos problemas que puedan ocurrir.
Cleaning Secondary Foam Filter
Limpieza del segundo filtro de goma espuma
Secondary
Foam Filter
Segundo fìltm
de goma espuma
The secondary foam filter protects the motor
El segundo fittro de goma espuma protege el motor
Check filter when Installing a new dust bag
Al instalar una nueva bolsa de polvo revise el filtro
If dirty, pull filter from bottom of dust compartment and
clean by rinsing in water
Si esté sudo, tire del filtro del fondo del
compartimento de polvo y limpíelo enjuagando con
agua
When dry, slide filter back into place
Cuando esté seco deslice el fíltre a su tugar
Ensure filter is fully inserted under plastic rib
projections
Asegúrese de que el filtro está instalado debajo de las lengüetas plásticas
Replacing HEPA Exhaust RIter
Cambiar del filtro de escape HEPA
The HEPA exhaust filter removes dirt from recirculated air
El filtro de
escape
HEPA quita el polvo del aire redclado
Check filter when Installing a new dust bag
Revise el filtro al Instalar una nueva bolsa de polvo
Dust
Cover
Cubierta
de polvo
ncrM
Exhaust Filter
and Frame
Filtro de
escape
HEPA y el marco
>~
If dirty, remove filter from bottom of the dust cover by pulling
straight up on retainers on frame. Lift one side at a time
Si esté sudo, quite el fíltre del tondo de la cubierta de polvo al tirar
hada arriba en las lengüetas del marco. Levante un lado y
después
el otro lado
Place new filter In dust cover DO NOT CLEAN WITH WATER*
Coloque el filtro nuevo en la cubierta de polvo No limpie con
agua*
Place filter in frame and install in dust cover, making sure
white side is facing up
Coloque el filtro en el marco y instale la cubierta de polvo asegurando de que el lado
¿Vaneo
dé
hada arriba
*Filter cannot be cleaned and should be replaced at least once each year
*No se puede limpiar el filtro y se debe cambiarlo a lo menos una vez cada aсo
-
15
-