Panasonic EY6812 - Manual (Page 7)

Operation # Reversing lever
® Chuck
Note: Grease for bits
Grease the oval indentation on
the bit with the supplied grease
at least once a month.
1. Align the oval uneven parts of the
bit with the marks on the chuck as
shown.
2. Turn the chuck counterclockwise.
Insert the bit to the chuck as far as
it will go.
3. Release the chuck when the bit Is
inserted completely.
(The
chuck goes back automati­
cally and the bit is fixed.)
4. Make sure that the bit Is fixed by
pulling it.
TypeA
It)“
5. To remove the bit, turn the chuck
counterclockwise, ar)d pull the bit.
Be sure to set the switch in the center to
lock it after use.
© Hammerlng/drilllng switching
lever
Selecting action mode
Position ol
«witohing Isver
Action mod« Material
T
Rotation with
hammedng
Concrata
mortar,
brick,
ate:
Rotation
oniy
Tlla, ate.
Note: Use drill mode when work with
fragile materials like tile, etc.
® Trigger
To set the center of a hole, pull the
trigger slightly to start the drill rotating
slavey.
- 7 -