Panasonic NAMPS HH950 - Manual (Page 123)

SÌQndI cai=]t=>c:
Call Receive
08:00 AM
Dec 05
To use Call Receive feature:
5. Return the ignition switch to normal OFF or LOCK
position. (Call Receive functions with ignition ON, also.)
MUTE
Call Receive
08:00 AM
Dec 05
6. Six seconds after an incoming call begins, the Receive
Call feature will answer the call and prompt the caller to
enter their return phone number (up to 32 digits) by
sounding two beeps 3 times. The caller sends their phone
number by conventional touch-tone (DTMF) up to 32 digits,
if the phone receives more than 32 digits, it automatically
terminates the call from that point. The display shows the
numbers corresponding to the DTMF tones from the caller.
7. Once the calling party is finished, the caller’s phone
number and time stamp are stored in memory. The
display shows the number of calls received (up to 10)
along with a time/date stamp.
MUTE
Call Receive
012345678 8. To recall this information, power ON the phone and
press [ rcl ] 1 # 1. Note the caller’s phone number, time
stamp of the last received call, and the total number of
unanswered calls appear on the display.
Signal =>=
RCVD Call
09:40 AM
1 Call
12th
9. Scroll the last ten numbers using the r+~) or (H)
keys.
NOTES:
RCL #
08;00A 12/05
This feature, when active, remains in effect even after
powering the phone OFF and then ON again.
The phone powers OFF automatically when time has
elapsed with the "Safety TimeF' feature.
When Full Lock or Receive Lock features are active,
power automatically goes OFF when the ignition switch
is OFF.
3-90 Vehicle Use Options (FCN 9) Operation