Attention, Specifications, Warning – Panasonic ER147 User Manual
Page 8: How to remove the built-in rechargeable batteries
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTENTION:
A nickel cadmium battery that is
recyclable powers the product you
have purchased.
At the end of its useful life, under
various state and local laws, it is
illegal to dispose of this battery into
your municipal waste stream.
Please call 1-800-8-BATTERY for
information on how to recycle this
battery.
1)
Remove the blade from the
clipper. Remove the 2 screws (a).
Remove the head block (b).
(Fig. 11)
2} Remove the 3 screws (c).
(Fig. 12)
3) Remove the bodycover
(housing) (d). (Fig. 13)
4) Remove the motor and remove
the circuit block (e) from the
housing. (Fig. 14)
5) Remove the batteries. (Fig. 15)
Specifications
Power source: 120V AC, 60Hz
Motor voltage: 2.4V DC
Charging time: 4 hours
How to remove the built-in
rechargeable batteries before
disposal of the clipper.
The batteries in this clipper are not
intended to be replaced.
The procedure described in Fig,
11-15 is intended only for the
purpose of proper disposal. Discard
the clipper after the batteries have
been removed.
WARNING:
Do not attempt to
replace the batteries for the
purpose of reusing the clipper.
This could result in the risk of fire.
rechargeable batteries>
Disconnect the clipper from the
outlet when removing the batteries.
Fully discharge the batteries.