beautypg.com

Caution – Panasonic WET/DRY RECHARGEABLE SHAVER ES4012 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Replacing the outer foil

(see fig. 7)
Squeeze the outer foil release but­

tons and lift the outer foil upward to

remove it. To insert the new outer foii,
press down until it snaps into place.

Replacing the inner blades

(see fig. 8)
Press the foil frame release button

to pop open the foil frame. Pull the
foil frame vertically out of the upright
shaver. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight

away from the shaver. To insert the

new inner blades, hold the blades,

one at a time, at both ends and press
downward until they snap into place.

ATTENTION:

The

product

you

have purchased is powered by a

nickel cadmium battery which is re­
cyclable. At the end of it’s useful

life, under various state and local
laws, it is illegal to dispose of this
battery into your municipal waste
stream. Please call 1-800-8-BAT-

TERY for information on how to

recycle this battery.

How to remove the built-in re­

chargeable battery

(see fig. 9)

The procedure described below is in­
tended only for removal of the re­
chargeable battery for the purpose

of proper disposal.

WARNING: Do not attempt to re­

place the built-in, rechargeable

battery yourself for the purpose of

reusing the shaver. This could re­

sult in the risk of fire or electric
shock. Please contact your near­
est authorized Panasonic service

center.

1 .Remove the cap, outer foil frame,

inner blades and trimmer, (see fig.
9A) (Trimmer must be pulled away

from main body using some force.)

2. Remove the trimmer driving bar (b)

and two screws (a), (see fig. 9B)

3. Remove two screws (c) and bot­

tom cover (d). (see fig. 9C)

4. Pull the chassis out of the hous­

ing. (see fig. 9D)

5.

Remove the batteries from the

chassis, (see fig. 9E)

Caution

• Do not charge the shaver where the

temperature is below 0“C (32°F) or
above 40°C (104“F), where it will
be exposed to direct sunlight or a

heat source, or where there is a lot
of moisture.

• Use only the included shaver

charging adaptor RE3-83 to charge
the ES4012 shaver.

• The supply cord of the charging

adaptor cannot be replaced; if the

cord is damaged, the entire charger
should be discarded.

• Dry the shaver completely before

setting it in the charging adaptor.

• Keep the charging adaptor away

from water and handle it only with

dry hands. Do not use an extension

8