Panasonic MJ-66PRA - Manual (Page 3)

HOW TO USE THE JUICE EXTRACTOR
i 1. Be sure the Clamps are correctly located and locked in
position before using the juice extractor.
2. Place a glass or bowl under the spout.
3. Preparation of fruit and vegetables:
• Cut large fruit and vegetables into smaller sizes so
that they can be easily put into the Feeder Opening.
• Strawberries, bananas, apricots,etc., are not
recommended,as juice will not be as thin as other fruits.
4. Plug the power cord into a convenient electrical outlet.
Your juice extractor is ready for use.
5. Press the Switch “ON”. Then put the fruit and vegetables
into Feeder Opening by using the Food Pusher.
6. After using,the Switch must be turned off and plug should
be disconnected.
CIRCUIT BREAKER PROTECTION
When circuit breaker automatically stops motor due to overloading: after 10 second
interval,switch off. Unplug. Complete the following instructions, then resume operation.
Cut ingredients small enough to fit into feeder opening. Push ingredients into feeder
gently; too much force activates circuit breaker.
HOW TO CLEAN THE STRAINER
1. Fill the Bottle with water and attach the Brush Unit as
shown. Do not use any other brush. Do not use the
Cleaning Brush when there Is no water in the Bottle.
2. Place a glass or bowl under the spout and push the
Switch “ON”.
3. Make sure that the Strainer is turning, then open the Lid
and insert the Cleaning Brush.
4. Move the Cleaning Brush back and forth while squirting
water from the Bottle. Be sure to insert the shaft
completely before pulling it back.
Do not switch the power on and off while the Cleaning
Brush is inserted,or the Strainer will be damaged.
5. After removing the Cleaning Brush, push the Switch “OFF”.
And unplug the unit.
6. Clean the Brush Unit after each use. Take the Strainer
out after cleaning and rinse it with clean water.