beautypg.com

Before use, Parts identification – Panasonic ES762 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Before use

This Wet/Dry shaver can be used

for wet shaving with shaving lather
or for dry shaving. You can use this
watertight shaver in the shower and

clean it in water. Treat yourself to

wet lather shaves for at least three
weeks and notice the difference.
Your Panasonic Wet/Dry shaver

requires a little time to get used to

because your skin and beard need
about a month to adjust to any new
shaving method.
Charge the shaver for at least 8
hours before using it for the first
time or when it has not been in use
for more than six months.

Parts identification

(see fig. 1)

® Protective cap
d) System outer foil release but­

tons

© Foil frame

© System outer foil
© Inner blade
© Foil frame release button
© On/Off switch
© Switch lock button
® Recharge lamp
Q) Charge status lamp

® Trimmer
® Trimmer handle
© Charging adaptor with auto­

matic voltage adjustment

© Wall mount

© Wood screws

How to use the wall mount

The charging adaptor can be hung
on the wall using wood screws.

1. Select an appropriate location on

the wall where the screws can go

in.

2. Attach the wall mount to the wail

as shown with the wood screws,

making sure that the arrow points
up.

3. Slide the charging adaptor

grooves into the wall mount until it
clicks in.

To remove the charging adaptor

from the wall mount, slide the adap­

tor upward.

Charging

(see fig. 2)

Place the charging adaptor upright

on a flat surface or mount it on a

wall. Plug the adaptor into an AC
outlet.

It will adjust automatically to volt­
ages between 100-120 and 220-

240V AC.

Do not recharge the shaver from the
SHAVERS ONLY outlet (AC 220-

240V) which is usually in hotel bath­

rooms in European and Asian coun­

tries as it will damage the charging

adaptor and/or outlet.
In some areas, a special plug adap­

tor may be required.

Switch the shaver to the “O charge
position" and place it upright into the

charging adaptor with the switch
facing toward the front.
The charge indicator lamp will glow

red and it will stay on until the

shaver is removed from the adaptor.
You can fully charge the shaver in 8

hours if the recharge lamp flashes
red.

A full charge will supply enough

power for about 14 shaves (three