CLIFFORD concept 50x - Manual (Page 9)

What each button/channel does
Your Concept 50x remote controls come pre-programmed so that certain channels
command certain functions. If you wish, you can actually assign any channel to any
function (see pages 16-20). The following chart indicates what each remote control
channel number does, and how to transmit each channel number.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1 arm or disarm and lock or unlock the doors no — 1
2
optionally turn on a timed device (if the system is armed)
AND
optionally pop the trunk (if the system is disarmed)
no — 2
3 silently arm or disarm no — 3
4 activate an optional accessory no — 4
5 arm or disarm a Concept 50x on your second vehicle yes once 1
6
Command a Concept 50x on your second vehicle to
optionally turn on a timed device (if the system is armed)
AND
optionally pop the trunk (if the system is disarmed)
yes once 2
7
activate an optional accessory
controlled by a Concept 50x on your second vehicle
yes once 3
8
activate another optional accessory
controlled by a Concept 50x on your second vehicle
yes once 4
9 enter/exit valet mode yes twice 1
10 remotely turn off one or both sensor zones yes twice 2
11
activate an optional accessory
controlled by a Concept 50x on your third vehicle
yes twice 3
12
activate another optional accessory
controlled by a Concept 50x on your third vehicle
yes twice 4
TO ARM
THE SYSTEM . . . . . . . Press button 1 (channel 1) once. You will hear two chirps and the
indicator lights will flash twice. The dashboard LED will flash
repeatedly and the car doors will automatically lock.
TO DISARM
THE SYSTEM . . . . . . . Press button 1 (channel 1) again. One chirp and one indicator
light flash confirms disarming. In addition, the doors will auto-
matically unlock and the interior lights will turn on and stay on
for 30 seconds or until you start the engine, whichever occurs first.
7