Panasonic ULTRA-PRO MC-V150 - Manual (Page 15)

' IBERli»»NG fH&BEüi
iSSSiS80il',iSSSSS-: -- ?' ■- ■■«i'- -
A
WARNING
Personal tniury Hazard,
Be careful when removing agitator. The txit tension is high. Failure to do so could result
In personal injury from agitator releasing quiddy and snapping away.
Unptug and turn the unit over. Remove the lower plate as described in the REMOVING/
INSTALLING THE LOWER PLATE section.
Remove the agitator, carefully lift it out, and remove tfie
worn or broken belt from the belt pulley and motor shaft.
NOTE:
The two end caps may come off as you lift the agi­
tator out.
Loop the new belt around the motor shaft and the belt pul­
ley on the agitator. See illustration for correct belt routing.
Use onty a Panasonic Type UB8 drive belt.
Before reinserting the agitator make sure the end caps are
on correctly. See illustration in the REPLACING THE AGI­
TATOR section.
After checking the end caps, reinstall the agitator back into the housing grooves. After installing
the agitator, turn it by hand making sure that the belt is not twisted or pinched and all rotating
parts turn freely. Replace the lower plate as described in the REMOVING/INSTALLING THE
LOWER PLATE section.
CMiilNGmEiAGiTAllDR
Switch off the vacuum cleaner and unptug the power
cord before cleaning the agitator. In order to keep the
cleaning efficiency high, clean the agitator regularly
Remove the lower plate if necessary. See the REMOV­
ING/! NSTALLING THE LOWER PLATE section
for the proper procedure.
Agitator - Cut off any carpet pile and lint
entangled around the agitator with a pair of
scissors as illustrated.
- 1 5 -