How to install the hob – CDA HCC762 User Manual

Page 13

How to Install the Hob

How to install the hob:
Overall dimensions of the hob: Width: 770mm Depth: 510mm
Worktop cut-out dimensions:

Width: 740mm Depth: 480mm

1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood

to ensure that you will have the required clearance. The cut-out (Fig5) shows a 60mm gap from the wall to the cut-out

edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted,

take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear

wall or splashback is 50mm.

2. Position the hob seal, as shown in (Fig.7), ensuring that the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig.8). Remove any excess

sealant after tightening the brackets. Do not over-tighten the fixing brackets.

3cm

4cm

65mm

470mm

550mm

150mm

Fig.5

Fig.6

400mm

650mm

185mm

60mm

480mm

560mm

190mm

Fig.7

Fig.8

740mm