Vermont Casting 3349 - Manual (Page 14)

14 14
Radiance Natural Vent Gas Heater
20004409
Install Rear Bracket and Log Set
1. Remove the logs from their packaging, and inspect
each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.
2. Install the left rear log by placing it on the rear log
bracket at the back of the firebox. (Fig. 28) The left
rear log should touch the back wall of the firebox.
Slide the left rear log to the left until the left side
lines up with the left bracket. (Fig. 28) When the left
rear log is in place the front left corner of the log
should rest on the decorative grate.
3. Install the right rear log by placing it on the rear log
bracket at the back toward the right. Make sure the
right side of the right rear log lines up with the right
bracket. (Fig. 29) NOTE: When the right and left rear
logs are in place, they should touch the back of the
firebox and each other.
4. Install the right log by engaging hole on the bottom
left of the right log with pin on the front left of the
right rear log. (Fig. 29) Set the bottom right of the
right log on the bracket and bring the bottom right
forward to come in contact with decorative grate on
the right.
5. Loosely sprinkle the lava rocks directly on top of the
burner just behind decorative grate. Use the lava
rock to cover brackets on the burner. Do not place
lava rocks toward back of burner. The lava rock is
shipped inside the finish bag assembly. (Figs. 29,
30)
Thermostat
Wire / Gauge Maximum Run
18 40 feet
20 25 feet
22 16 feet
Thermostat Connection (optional)
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge
thermostat wire to use for the length of lead required in
your installation.
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4” female connectors.
2. Connect the thermostat wires to the valve. (Fig. 26)
PILOT
ADJ
TP
TH
TPTH
ST228
Fig. 26 Attach switch wires to valve.
Install the Mesh and Grille
Place the mesh and grille on the top of the Radiance
stove to complete assembly.
Rear Log
Bracket
LG158
Fig. 27 Radiance firebox and rear log bracket.