Leica Geosystems Leica mojo3D - QuickStart Guide - Manual (Page 2)

Select a guidance pattern
For A+ Heading
For Curve (or contour)
Press A then drive
contour, then press B
While driving the contour a straight line can
be created between when the pause and the
play buttons are pressed.
For Pivot
Adjusting waylines
Changing and Selecting
Drive at least 30 m between
each point
Nudging a wayline can be done by touching
the lightbar on the navigation screen to reveal
the buttons.
Enter heading
in degrees
Current waylines will be cleared
from the screen
Allows user to enter a fi eld offset
Leica mojo3D (used with RTK)
GPS and System Status
Leica mojo3D (used without RTK)
The quality of the GPS Signal is displayed.
Changing reference type
Allows user to change between reference
types.
Cell signal strength
Base station radio signal quality
Network Signal quality
Guide Signal quality
Changing and Selecting
Select a guidance pattern
For AB parallel
For Ultimate Curve
Changing and Selecting
Select a new fi eld
Treatment map must be OFF
Enter the name of the treatment you wish
to use
Select a new boundary
Select the side of the implement to create
the boundary and close by driving over the
start or pressing the icon in the centre of the
screen.
Drive at least 30 m between
each point
The next run lines will be generated both sides
of the treatment.
Start treatment
mapping
Leica mojo3D Main Menu
The Service menu
provides access to
Virtual Wrench and
Software upgrades.
The Mapping menu
allows for boundary and
treatment maps to be
created and saved.
The Guidance menu
provides different
guidance patterns.
The Settings menu
allows the user to
confi gure the mojo3D.
The Autosteer
Settings menu allows
the user to setup and
tune the auto steering.
Section control button Autosteer engage/disengage
Confi gurable buttons
Touch screen to reveal zoom
Touch lightbar to reveal nudge
Menu buttons