Leica Geosystems Leica DISTO D810 touch - Manual - Manual (Page 39)

Leica DISTO TM D810 touch 799093a 38
EN Message Codes
If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a number,
press the Clear button and observe the
following instructions:
Care
• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents or
solvents.
Warranty
Lifetime Manufacturer's Warranty
Warranty coverage for the entire usage time
of the product according to Leica Geosys-
tems International Limited Warranty. Free of
charge repair or replacement for all products
that suffer defects as a result of faults in mate-
rials or manufacturing, for the entire life of
the product.
3 Years No Cost
Guaranteed service should the product
become defective and require servicing
under normal conditions of use, as described
in the user manual, at no additional charge.
To receive the "3 years no cost" period, the
product must be registered at www.leica-
geosystems.com/registration within 8 weeks
of the purchase date. If the product is not
registered, a "2 years no cost" period applies.
Functions
Distance measuring yes
Min/Max measuring yes
Permanent measuring yes
Stake-out yes
Addition/Subtraction yes
Area yes
Triangle area yes
Volume yes
Trapezium yes
Painter function (area with partial
measurem.) yes
Pythagoras 2-point, 3-point
Smart Horizontal Mode /
Indirect height yes
Height-profile measurement yes
Level yes
Sloped objects yes
Height tracking yes
Memory yes
Beep yes
Illuminated colour display yes
Multifunctional endpiece yes
Pointfinder (Viewscreen) 4x zoom, OV
Bluetooth
®
Smart yes
Personalized Favorites yes
Timer yes
Long Range Mode yes
Calculator yes
Photo/Screenshot yes
Compass yes
Gallery with USB download yes
Diameter yes
Width yes
Area from Photo yes
No. Cause Correction
156 Transverse tilt greater
than 10° Hold the instrument
without any transverse tilt.
162 Calibration mistake Make sure, the device is
placed on a absolutely
horizontal and flat surface.
Repeat the calibration
procedure. If the mistake
still occurs, contact your
dealer.
204 Calculation error Perform measurement
again.
240 Data transfer error Repeat procedure.
252 Temperature too high Let device cool down.
253 Temperature too low Warm device up.
255 Received signal too
weak, measuring time
too long Change target surface
(e.g. white paper).
256 Received signal too
high Change target surface
(e.g. white paper).
257 Too much back-
ground light Shadow target area.
258 Measurement outside
of measuring range Correct range.
260 Laser beam inter-
rupted Repeat measurement.