Crane & Co. EE-5607 - Manual (Page 6)

5
BEFORE FIRST USE
IMPORTANT: Remove the clear plastic sticker that is visible at the bottom of the
remote controller (see drawing below).
HOW TO ASSEMBLE
NOTE: Refer to LIST OF MAIN PARTS on page 4.
1. Lay the main body of the fan gently on floor, take the base (3) and place power
cord (6) in the cord groove.
2. Attach the fan body and the base by tightening the base screws (4) with a
screwdriver.
3. Secure power cord (6) to base (3) with clamp screws (5).
HOW TO OPERATE
How to Locate the Remote Controller
The remote controller can be removed from remote controller holder, at the back of the
tower fan near the top (see drawing below).
Note: Before first use, remove clear
plastic sticker
How to Operate Tower Fan Control Buttons
POWER
On – Green Light
Off – Light turns off
To start or stop the fan
SPEED Low speed - Red
Mid speed - Orange
High speed -Green
To adjust the Speed Level of
the fan, press fan speed
button (low / medium /
high).
WIND On -Orange
Off - Light off
To set a natural wind mode
TIMER 2 hours - Red
4 Hours - Orange
8 hours – Green
Off – Light off
To set the timer level: 2 / 4 /
8 hours
OSCILLATION 180 Degrees –Green
120 Degrees – Orange
60 Degrees-Red
Off - Light off
To start or stop the
oscillation of fan
PLEASE NOTE: When you turn off the fan, either manually or with remote
control, the fan will automatically move to the starting position of 90 degrees
before the fan comes to a complete stop.