Leica Geosystems Leica DISTO D3a - User Manual User Manual

Page 14

Measuring

Leica DISTO™ D3a 776175a gb

FIN

ROK

RUS

Minimum/maximum measurement

This function allows the user to measure the
minimum or maximum distance from a fixed
measuring point. It can also be used as to determine
spacings.

It is commonly used to measure room diagonals
(maximum values) or horizontal distances (minimum
values).

Press and hold down this button until you hear

a beep. Then slowly sweep the laser back and forth
and up and down over the desired target point - (e.g.
into the corner of a room).

Press to stop continuous measurement. The

values for maximum and minimum distances are
shown in the display as well as the last measured
value in the summary line.

Laser continuous

Press and hold down the key when switching

on the device until the character

appears perma-

nently in the display and a beep sounds. Every further
press of the

key releases a distance measure-

ment.

Press the key and hold to switch the device

and Laser continuous operation off.

)

If the laser is in continuous operation mode,

the device switches off automatically after 15
minutes.

min.

max.