CBM America iDP3240 - Manual (Page 128)

— 109 —
GS V m ......... (1)
GS V m n ..... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H
(2) <1D>H<56>H
[Range] (1) m = 1, m = 49
(2) m = 66
0 n 255
[Outline] Performs the specified paper cutting.
m Function
1,49 Partial cut (Leaving a bridge area uncut)
66
Paper feed by “cut position + {n
×
basic calculation
pitch}” and partial cut (Leaving a bridge area uncut)
[Caution] • In STANDARD MODE, this command only works when it is
entered at the beginning of a line.
For (1):
• A partial cut (Leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠
0, the paper is fed by “n
×
basic calculation pitch” past the
cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic
calculation pitch (y).
A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.