Leica Geosystems Roteo 20HV, 25H, 35, 35G User Manual
Leica Geosystems Equipment
Table of contents
Document Outline
- Introduction
- Contents
- Features
- Laser Overview {A}
- 1) Rotating head
- 2) Aluminum head protection with axes indications
- 3) Plumb or square beam laser beam aperture
- 4) Rotating laser beam aperture
- 5) Index marks for alignment and 90°
- 6) Motorized wall or floor mount
- 7) Batteries
- 8) Jack for battery charger
- 9) 5/8"-11 Tripod mount for horizontal setup
- 10) 5/8"-11 Tripod mount for vertical setup
- 11) Sensors for remote control signal
- 1) Rotating head
- Keypad Overview {B}
- 1) Automatic / Manual Mode
- 2) Scan / Rotation Mode
- 3) On / Off
- 4) H.I. (Elevation) Alert
- 5) Motorized Mount On / Off
- 6) CCW Scan-Stationary Beam / Manual Slope
- 7) CW Scan-Stationary Beam / Manual Slope
- 8) Minus – Head Speed / Scan Width / Motorized Mount
- 9) Plus – Head Speed / Scan Width / Motorized Mount
- 10) LED’s – X/Y Axis Level Indicators (2) – Green (self- leveling), Red (manual)
- 11) LED – Motorized Mount Enabled
- 12) LED – H.I. Alert
- 13) LED – Low Battery
- 1) Automatic / Manual Mode
- Carrying Case Overview {C}
- Basic Operation
- Set-up and applications
- Accessories
- Batteries
- Check and Adjust
- Troubleshooting
- Care and Transport
- Safety Directions
- Technical Data
- International Limited Warranty