4 setup>test, Setup>test – Dillon EDjunior (Red) User Manual
Page 16
14
EDjunior Dynamometer User Instructions
5.4 Setup>Test
The Test functions can help service technicians remotely diagnose your Dillon
instrument by showing information on key internal functions. Typically these menus will
have significance only to trained technicians . You may look at these menus without
technical guidance, but the information may have little meaning, or an error may be
reported that may not exist.
Press this key to access several items described below (refer to Figure
):
Batt
Press this key to perform a battery test. This shows the battery level in A-
D counts and approximate voltage. Voltage is not calibrated.
A-D
Press this key to test the A-D section of the EDjr. You need to apply force
to change the counts and test the unit. The A-D is the electronics portion
that converts analog load cell signal to digital numbers.
Disp.
Press this key to perform a display test. Stop the test by pressing the ESC
key.
Keys
Press this key to perform key tests. Any key pressed will be reflected in the
display. Press to end the test.