C. Crane CC Solar Observer Radio - Manual (Page 7)

CC Solar Observer Page 7
Getting Started –Powering Your Radio
Power by Charging Adapter
(optional accessory not included) —
Connect the AC charging adapter between a 120Volts/60Hz wall outlet and
the “BATTERY PACK CHARGING JACK” on the side of radio (see location
of jack on page 5). To fully charge the battery pack, keep the charging
adapter plugged in overnight. When the battery pack is fully charged, the
radio should play for over 15 hours.
Note:
The AC charging adapter should only be used to charge the battery
pack and should not be used to power the radio on a constant basis.
Leaving the charging adapter plugged into the radio for long periods of
time will shorten the life of the internal battery pack.
Internal
Battery Pack
Fold Out
Solar Panel
Install 3 “AA”
batteries as
shown here.
Inserting Batteries:
1. Position the radio face down on a soft surface to protect it.
2. Remove the battery compartment cover.
3. Insert the 3 “AA” cell batteries into the compartment, as indicated in the
picture below. Be sure the negative (-) end is against the spring.
Refer to the picture below to insure correct installation of your batteries.
4. Replace the battery cover. On the front of the radio, slide the “Power
Switch” to “Battery” to turn the radio on.