Sangean PR-D3L (V1) User Manual

Page 10

RADIO ALARM

(1) Select the Radio Alarm mode by pressing alarm mode button.
(2) If radio alarm is selected, when the alarm is on, the radio will
play the last station selected.

HWS ALARM

A repeating beep tone will sound when using HWS alarm.
The alarm beep will increase in volume every 15 seconds for one
minute followed by 1 minute silence before repeating the cycle.
The HWS alarm will sound for one hour unless turned off by
pressing the POWER button.

SNOOZE

When the alarm is on, press any buttons except POWER button,
the alarm will be in Snooze function for an interval of 5 minutes
before pressing POWER button to turn it off. Display will flash
Snooze symbol and alarm status.

RADIO OPERATION

WAVEBAND SELECTION

There are three wavebands in PR-D3L unit
Waveband Frequency Aerial Type
FM 87.50 - 108 MHz Telescopic
Fully extend the aerial,
angle and rotate for best reception.
MW 522 - 1710 kHz Internal
Rotate for best reception.
LW 144 - 279 kHz same as MW

There are 4 different available tuning methods:
Manual tuning, Rotary tuning, Scan tuning and Memory recall tuning.