Sangean DPR-99+ (R1) User Manual

Page 17

Stereo / Mono setting - FM

Your radio will play stereo broadcasts in stereo (via headphones) so
long as the received signal is of adequate strength. However, as a
stereo signal becomes weaker the audio signal will become poorer.
It may be preferable to force the radio to play the station in mono in
order to reduce the level of audio noise.

1. Press the On/Off button to switch on your radio.

2. Tune to the required FM radio station as previously described.

3. Press and hold the Info/Menu button until the display shows
“Mono Override” on the lower line.

4. Press the Select button to enter the Mono Override menu. The lower
line will show “Override Off“ if the radio is in the Auto-Stereo mode.
Press the Tuning Up or Down button to switch on the mono Override.
While this setting is engaged, the radio will play the current station
in mono whether listening via headphones or the loudspeaker.

Mono Override is a temporary setting and is applied to the currently
tuned station only. It is cancelled automatically by tuning to another
radio station.

5. If you wish to cancel Mono Override while listening to the currently
tuned radio station, press and hold the Info button until the display
shows “Mono Override“ on the lower line. Press the Select button to
enter the Mono Override menu. The lower line will show “Override On“
if the radio is in the Mono Override mode.

6. Press the Tuning Up or Down buttons, the lower line shows
“Override Off“. Press the Select button to switch off the
Mono Override. The radio will then play the current station in stereo
through headphones if the signal is sufficiently strong.