Sangean DDR-43+ (R1) - Manual (Page 41)

39
Standby brightness control
The brightness of the display when the unit is in standby mode may
be adjusted. If you use the unit in the bedroom, you may prefer a lower
standby brightness level than the standard setting.
1. Press and hold the Menu button so that the display shows
“Set Brightness” on the lower line of the text display
2. Press and release the Select button to show the current setting.
3. Press and release the Tuning Up or Down buttons to change the
standby brightness level. The backlight level will change at the same
time so that you can see the effect of the change.
4. Press and release the Select button to save the new setting.
The default setting after a system reset is 5. Possible brightness values
range from 1 - 7.
GB