Sangean PAKKET 404 (V1) - Manual (Page 9)

removed form the display.
Light
Pressing the light button located on the top of the radio will turn on the light and illuminate
the display for approximately 7 seconds.
MW step switch
1.This switch located on the bottom side of the radio provides a means of changing the
MW step from 9kHz to 10 kHz. In Europe and most other parts of the world, set the
switch to the 9 kHz position. For the USA and Canada, set the switch to the 10kHz
position.
Troubleshooting /RESET button
If the radio fails to operate correctly, or some digits on the display are missing or incomplete,
carry out the following procedure.
1.Switch off the radio and remove the batteries.
2.With the aid of a suitable implement (the end of a paper clip or pen), press the RESET
button located in the battery compartment for at least 5 seconds, this will reset the
microprocessor, clock time and clear all stations stored in the preset memory.
Care and maintenance
Do not allow this radio to be exposed to water, steam or sand ,Do not leave the radio where
excessive heat could cause damage such as in a parked car where the heat from the sun
can build up even though the outside temperature may no Seem too high.
Specifications
Frequency range
FM 87.5 - 108 Mhz
MW 520-1710 or 522 - 1710 kHz
SW 120m 2.3 - 2.495 MHz
90m 3.2 - 3.4 Mhz
75m 3.85 - 4.0 MHz
60m 4.75 - 5.06 MHz
49m 5.9 - 6.2 MHz
41m 7.1 - 7.35 MHz
31m 9.4 - 9.99 MHz
25m 11.6 - 12.10 MHz
21m 13.57 - 13.87 MHz
19m 15.1 - 15.8 MHz
16m 17.48 - 17.9 MHz
15m 18.9 - 19.02 MHz
13m 21.45 - 21.75 MHz
11m 25.6 - 26.1 MHz
Specification content
Power requirement 6V
Batteries 4 X IEC size Lr6 (AA) (UM-3)
Battery life Approx .16-20 hours of listening when used for 4 hour
a day at normal volume using alkaline batteries.
9