Network profiles – Sangean WFR-28D (R2) User Manual

Page 77

Network profiles

Each time that you connect your radio to a WiFi network, the radio will store the details of that

connection (SSID, security key, DHCP/IP address settings) as a profile. Up to four such profiles

are stored in the radio so that if the unit is used in multiple locations there is no need to enter the

network settings when returning to a location previously visited.

The radios stores the four most recent profiles in memory identified by their SSID. Normally the

radio will attempt to connect to one of the stored profiles and only if it is unable to do so will you

need to use the Network Wizard.

In the event that you visit a location only once you may wish to delete the profile for the network

in that location to avoid losing other profiles.

1. Access the menu for the current mode by pressing the

Menu button. Rotate the Tuning Control

Rotary until 'System settings' is highlighted on the display. Press the Tuning Control Rotary

to enter the settings menu.

. Rotate the

Tuning Control Rotary until 'Network' is highlighted on the display. Press the

Tuning Control Rotary to enter the Network settings menu.

. Rotate the

Tuning Control Rotary until 'Network profile' is highlighted on the display. Press

the

Tuning Control Rotary to see the stored profiles. The profile which is currently in use (if

any) is marked with an asterisk.

4. To remove a profile from memory, rotate the

Tuning Control Rotary to highlight the profile to

be deleted and then press the

Tuning Control Rotary to confirm the setting.

5. The radio will offer a 'YES' or 'NO' selection. Rotate the Tuning Control Rotary to select 'YES'

and then press the

Tuning Control Rotary to confirm the setting. The selected profile will be

deleted.

Note: that it is not possible to delete a profile which is currently in use.